Posted by iTize, 10-26-2014, 07:14 AM | Hello everyone.
Now every day I passed the same problem and Plesk does not update correctly.
Anyone know how I can update it from SSH console please?
I think I have some port that is blocking CSF Plesk.
Thank you very much.
http://www.webhostingtalk.com/showth...23#post9272223
Old conversation:
Solvented:
http://www.webhostingtalk.com/showth...23#post9272223
|
Posted by iTize, 10-26-2014, 07:35 AM | I have the following ports open if it is helpful.
To automatically update Plesk.
I have Plesk version 11.5.30.
And seems to want to upgrade to version 12.0.18
# Allow incoming TCP ports
TCP_IN = "20,21,22,25,53,80,110,143,443,465,587,993,995,69,5224"
# Allow outgoing TCP ports
TCP_OUT = "20,21,22,25,53,80,110,113,443,5224"
|
Posted by Onra Host, 10-26-2014, 09:42 AM | Can you disable CSF and try running the plesk update after?
In SSH run command > csf -f
Next run Plesk Update
Then start it again by> csf -s
If it works then you know it was CSF Also depending on your security settings sometimes you need to whitelist IP's (in this case the Plesk server updates are trying to be grabbed from)
|
Posted by iTize, 10-26-2014, 06:32 PM | Hello, your solution is perfect, the problem was fixed.
Thank you very much !!!
I just need to know which ports are used to upgrade Plesk to add it to the whitelist.
Thank you very much master.
|
Posted by Srv24x7, 10-27-2014, 09:16 AM | Hi,
I personally would not advise using CSF on a plesk server. Plesk has its own integrated firewall, that is the best.. Check the below TCP ports enabled, you don't have standard Plesk ports 8880, 8443, and most important 8447 needed for Plesk update added in this.
-------------------------------
# Allow incoming TCP ports
TCP_IN = "20,21,22,25,53,80,110,143,443,465,587,993,995,69,5224"
# Allow outgoing TCP ports
TCP_OUT = "20,21,22,25,53,80,110,113,443,5224"
-------------------------------
Remove the CSF and configure the Plesk in-built firewall.
|
Posted by iTize, 10-30-2014, 08:37 AM | Hello Srv24x7.
Thank you very much for your help and sorry for delay in responding.
Do not use the plesk firewall why not block countries like China as they always attack my server.
And so now I have put csf.
Thanks for the port.
|
Posted by Srv24x7, 10-31-2014, 10:29 AM | Hi,
Okay, when it comes to blocking the country, you can then rely on CSF, as it does very good job of blocking the traffic as configured in CC_DENY.
In addition, you can also use the fail2ban.
|
|
Add to Favourites
Print this Article |